If you create a loop with angular straight sides, you can add a wide variety of side-drilled beads to your jewelry designs. I made this pair of earrings using 26 gauge wire. Grab a pair of straight pliers and try this wirework technique to add to your jewelry making skills.

Tools needed:

You’ll need a pair of needle-nose (straight) pliers and a second pair of any kind of pliers as backup.

The following picture is a step-by step graphic showing the bends you need to make on the wire with straight pliers. For better visibility I’ve used heavier wire, 20 gauge in this photograph. When I made the example earrings, I used 26 gauge gold art wire and 7 x 12mm leaf beads, not the 20 gauge dark wire and wide petals you see in the step-by-step graphic.

Cut a piece of wire about 5 inches long. 1. With the straight pliers, bend the bottom two inches to a 45 degree angle. 2. At about three-eighths or a quarter inch after the first bend, bend again. Thread a side-drilled bead on. 3. The third bend should be done at a length so that a flat triangle with equal sides is formed. 4. Between the jaws of the straight pliers, keep a firm hold on the spot where the wire crosses the top of the triangle. While keeping a stable hold and not allowing anything to move, wrap the end of the wire two or three times around the upright wire and trim. If the triangle clotheshanger shape is wonky, straighten and sharpen the corners with the straight pliers.

Your clotheshanger dangle is done! Now you can add beads to make the main body of your earring, finishing the link using the conventional wrapped loop technique. Add more links as desired, and add earwires.